Tag: naze32
-
How to Set up a QAV250
How to setup a QAV250 [x_video_embed type=”16:9″][/x_video_embed] In part 1 of this three part post I talked about how important it is to carefully choose your components when building a QAV250. In part 2 we installed the ESCs, OSDoge and motors. Part 3 will be installing the FPV camera, video transmitter, set up the Taranis…
-
How to Remove Header Pins off a Naze32
Here’s the best way I found to remove header pins from a Naze32 or any other header pins off a circuit board. I’ve destroyed 2 Naze32 boards and a D4R-ii until I figure this out. If you try to remove the header pins intact by trying to remove the solder by wicking or manually removing…
-
Quadcopter Flips on Takeoff: Naze32 Orientation
I learned this the hard way. If your quadcopter flips or pirouettes on take off, there could be three reasons for this: The motors are spinning the wrong way. Use the motors tab in Baseflight or Cleanflight to check the motor directions. To reverse a motor, switch any two of the three motor wires. *Take off…